Linux version 2.4.8-pre3 (root@diana) (gcc version 2.95.3 20010315 (release)) #1 Tue Jul 31 23:06:55 EDT 2001
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f000 (usable)
 BIOS-e820: 000000000009f000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000000fff0000 (usable)
 BIOS-e820: 000000000fff0000 - 000000000ffff000 (ACPI data)
 BIOS-e820: 000000000ffff000 - 0000000010000000 (ACPI NVS)
 BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Scan SMP from c009f000 for 4096 bytes.
On node 0 totalpages: 65520
zone(0): 4096 pages.
zone(1): 61424 pages.
zone(2): 0 pages.
mapped APIC to ffffe000 (01442000)
Kernel command line: BOOT_IMAGE=linux ro root=305 video=vesa:ypan,pmipal
Initializing CPU#0
Detected 850.033 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1697.38 BogoMIPS
Memory: 254916k/262080k available (1424k kernel code, 6776k reserved, 497k data, 220k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0183f9ff c1c7f9ff 00000000, vendor = 2
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 64K (64 bytes/line)
CPU: After vendor init, caps: 0183f9ff c1c7f9ff 00000000 00000000
CPU:     After generic, caps: 0183f9ff c1c7f9ff 00000000 00000000
CPU:             Common caps: 0183f9ff c1c7f9ff 00000000 00000000
CPU: AMD mobile AMD Duron(tm) Processor stepping 01
Enabling fast FPU save and restore... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfd8b0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router ALI [10b9/1533] at 00:07.0
  got res[10000000:10000fff] for resource 0 of Texas Instruments PCI1420
  got res[10001000:10001fff] for resource 0 of Texas Instruments PCI1420 (#2)
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Starting kswapd v1.8
devfs: v0.107 (20010709) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
ACPI: Core Subsystem version [20010615]
ACPI: Subsystem enabled
Power Resource: found
EC: found, GPE 25
ACPI: System firmware supports S0 S1 S3 S4 S5
Processor[0]: C0 C1 C2, throttling states: 8
Battery: socket found, battery present
AC Adapter: found
Power Button: found
Sleep Button: found
Lid Switch: found
Thermal Zone: found
vesafb: framebuffer at 0xee000000, mapped to 0xd0809000, size 8192k
vesafb: mode is 1024x768x32, linelength=4096, pages=1
vesafb: protected mode interface info at c000:7652
vesafb: pmi: set display start = c00c7673, set palette = c00c76d6
vesafb: scrolling: ypan using protected mode interface, yres_virtual=2048
vesafb: directcolor: size=0:8:8:8, shift=0:16:8:0
Console: switching to colour frame buffer device 128x48
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
Real Time Clock Driver v1.10d
block: queued sectors max/low 169224kB/56408kB, 512 slots per queue
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller on PCI bus 00 dev 78
PCI: No IRQ known for interrupt pin A of device 00:0f.0. Please try using pci=biosirq.
ALI15X3: chipset revision 195
ALI15X3: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x1000-0x1007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x1008-0x100f, BIOS settings: hdc:DMA, hdd:pio
hda: HITACHI_DK23BA-20, ATA DISK drive
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
hdc: TOSHIBA DVD-ROM SD-C2502, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 39070080 sectors (20004 MB) w/2048KiB Cache, CHS=2432/255/63, UDMA(33)
hdc: ATAPI 24X DVD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4 < p5 p6 >
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
Linux Tulip driver version 0.9.15-pre6 (July 2, 2001)
PCI: Enabling device 00:10.0 (0010 -> 0013)
PCI: Assigned IRQ 11 for device 00:10.0
PCI: Sharing IRQ 11 with 00:04.0
PCI: Sharing IRQ 11 with 00:04.1
PCI: Sharing IRQ 11 with 01:00.0
eth0: ADMtek Comet rev 17 at 0xd100e000, 00:D0:59:5C:11:07, IRQ 11.
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 203M
agpgart: Detected Ali M1647 chipset
agpgart: AGP aperture is 64M @ 0xf0000000
Linux Kernel Card Services 3.1.22
  options:  [pci] [cardbus] [pm]
PCI: Assigned IRQ 11 for device 00:04.0
PCI: Sharing IRQ 11 with 00:04.1
PCI: Sharing IRQ 11 with 00:10.0
PCI: Sharing IRQ 11 with 01:00.0
PCI: Assigned IRQ 11 for device 00:04.1
PCI: Sharing IRQ 11 with 00:04.0
PCI: Sharing IRQ 11 with 00:10.0
PCI: Sharing IRQ 11 with 01:00.0
Intel PCIC probe: not found.
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
Yenta IRQ list 04b8, PCI irq11
Socket status: 30000006
Yenta IRQ list 04b8, PCI irq11
Socket status: 30000006
PCI: Found IRQ 9 for device 00:02.0
usb-ohci.c: USB OHCI at membase 0xd102a000, IRQ 9
usb-ohci.c: usb-00:02.0, Acer Laboratories Inc. [ALi] M5237 USB
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 220k freed
Adding Swap: 514072k swap-space (priority -1)
Winbond Super-IO detection, now testing ports 3F0,370,250,4E,2E ...
SMSC Super-IO detection, now testing Ports 2F0, 370 ...
0x378: FIFO is 16 bytes
0x378: writeIntrThreshold is 16
0x378: readIntrThreshold is 16
0x378: PWord is 8 bits
0x378: Interrupts are ISA-Pulses
0x378: ECP port cfgA=0x10 cfgB=0x4b
0x378: ECP settings irq=7 dma=3
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,COMPAT,ECP]
parport0: irq 7 detected
parport0: cpp_daisy: aa5500ff(38)
parport0: assign_addrs: aa5500ff(38)
parport0: cpp_daisy: aa5500ff(38)
parport0: assign_addrs: aa5500ff(38)
lp0: using parport0 (polling).
lp0: console ready
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0800-0x08ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x408-0x40f 0x480-0x48f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
PCI: Assigned IRQ 5 for device 00:08.0
PCI: Sharing IRQ 5 with 00:08.1